Important Instructions Before Use:

1. Before using, please clean your nails and remove dead skin with the provided tools, ensuring your nails are neat and tidy.
2. Avoid contact between the clay and acetone, metals, nitrile, formaldehyde-containing furniture, and fabrics, as these chemicals can contaminate the clay and prevent it from curing. Always keep your hands clean.
3. Curing time is affected by temperature; the lower the temperature, the slower the curing process. At a normal room temperature of 28-30°C, it takes 2-3 minutes to cure.
4. Please use the product as soon as possible after receiving it to avoid instability or failure due to storage or prolonged exposure to light.
5. Be sure to watch the instructional video and read the manual. Although the method is simple, pay attention to the details as following the instructions can help avoid many unknown risks.
6. This product can only be molded once; it cannot be restored after curing. The cured mold can be reused.

Nail Cap Mold Instructions (Molding Clay)

1. Take three small pieces of white and purple clay (about the size of a peanut).
2. Quickly mix one small piece of white clay with one small piece of purple clay until well blended.
3. Divide the mixed clay into two portions (if the thumbnail is larger, you can skip dividing).
4. Wrap both nail surfaces completely, ensuring the nail cap is fully covered and mark accordingly.
5. At a room temperature above 25°C, allow to set and cure for 3-5 minutes (curing takes longer at lower temperatures). Remember to apply a thin layer of nourishing oil inside the mold and on the edges to facilitate demolding. Repeat the above steps for other fingers.

Nail Cap Mold Numbering (Use a toothpick to mark)

• Left Hand Thumb to Pinky: L1, L2, L3, L4, L5
• Right Hand Thumb to Pinky: R1, R2, R3, R4, R5

Nail Mold Instructions (Casting Clay)

6. Take clay from the purple and white clay again, and repeat steps 1, 2, and 3. Ensure the clay is smooth and divide into two portions (based on the finger mold’s capacity) and press tightly into the mold while marking.
7. At temperatures above 25°C, allow it to sit for about 3-5 minutes to cure (keep a close eye on the curing process and separate the nail cap mold in time; too long curing may lead to sticking). Carefully pry open a gap along the interface between the mold and the model, slowly separate, and demold, placing them in the storage box in order.

Nail Mold Numbering (Use a toothpick to mark)

• Left Hand Thumb to Pinky: L1, L2, L3, L4, L5
• Right Hand Thumb to Pinky: R1, R2, R3, R4, R5